MoreCharles Ross & Son Co. has announced the completion of a new model of its line of ribbon blenders: the 42NSD.
The blender’s new design features a discharge screw positioned across the entire bottom of the trough and powered by a separate direct drive system for independent speed control. The discharge screw assembly is designed with very close tolerances between the screw and the trough. The screw runs forward only during the discharge cycle and in reverse during the blending cycle, which helps to eliminate dead zones and enhance mixing.
The 10 cu.ft. unit has stainless steel type 316 construction, a 150-grit finish on all surfaces, a dust tight two-piece cover with clamps, liquid spray nozzles, a 3” diameter discharge screw, load cells and a NEMA 12 stainless steel control panel.
More information: phone (800) 243-ROSS
The blender’s new design features a discharge screw positioned across the entire bottom of the trough and powered by a separate direct drive system for independent speed control. The discharge screw assembly is designed with very close tolerances between the screw and the trough. The screw runs forward only during the discharge cycle and in reverse during the blending cycle, which helps to eliminate dead zones and enhance mixing.
The 10 cu.ft. unit has stainless steel type 316 construction, a 150-grit finish on all surfaces, a dust tight two-piece cover with clamps, liquid spray nozzles, a 3” diameter discharge screw, load cells and a NEMA 12 stainless steel control panel.
More information: phone (800) 243-ROSS
