epoxies

EpoxySet to Feature Award-Nominated, Delay-Cure Adhesive at MD&M WEST

The one-part epoxy can reportedly be activated by UV or blue light from 365-405 nm with an intensity of about 150 mW/cm2 for 5-10 sec.

November 22, 2019

No Comments

EpoxySet Inc. recently announced that it will showcase its FLASHBOND UV-5608DC delay-cure epoxy at MD&M West, which will be held February 11-13, 2020, in Anaheim, Calif.

ROBNOR RESINLAB: Epoxy Foam for Void-Filling Applications

According to the company, this epoxy foam offers good adhesion to a variety of substrates, is particularly suitable for void-filling applications, and has good compressive strength for the backfilling of parts.

October 17, 2019

No Comments

Robnor ResinLab recently announced the launch of a new development material, PX19-GE3259-03.

What Are Structural Adhesives?

Structural adhesives can offer stronger bonds than mechanical fasteners.

Simla Ay

October 10, 2019

No Comments

A structural adhesive is a “load-bearing” adhesive that is used to bond a joint and is capable of holding two or more substrates together under stress.

Adhesive Technologies Help Electric Vehicles Go the Distance

New adhesives, sealants, and foams can address the thermal and weight challenges of modern high-voltage vehicle batteries.

Volker Oehl

October 1, 2019

No Comments

The desire to reduce vehicle emissions, especially in densely populated areas, is driving the replacement of combustion engine-powered cars with electrical vehicles.

PANACOL-ELSOL GMBH: Clear UV Adhesive for Electronics Applications

The epoxy-based adhesive reportedly hardens with UV light within a few seconds and can be used for semiconductor production due to its low ion content.

September 26, 2019

No Comments

At this year’s Bondexpo, which will be held October 7-10 in Stuttgart, Germany, Panacol will present Vitralit UC 1535, a new transparent adhesive specifically designed for use in electronics.

EPOXIES, ETC.: Technical Bulletin on Low-Outgassing Epoxy Adhesives and Potting Compounds

Epoxies, Etc. reports that it offers a number of products that meet NASA’s low-outgassing standard.

September 19, 2019

No Comments

Epoxies, Etc. has published a technical bulletin focused on low-outgassing epoxy adhesives and potting compounds.

Ask Dr. Dave

What are the best adhesives and sealants to use for home repairs and craft projects?

Dr. Dave details adhesive and sealant selections for various consumer applications.

Dave Dunn Ph.D.

August 26, 2019

No Comments

Over a long career, I have worked with several adhesive and sealant technologies and have tried many of them at home.

Improving Coating Efficiency with Dispensing Technology

Applicator-friendly cartridge-based coating dispensing technologies can help reduce labor, waste, and disposal costs.

Rob Rochette

August 14, 2019

No Comments

In response to environmental concerns, many industries are moving from protective coating products containing solvents to 100% solid epoxies and urethanes.

Master Bond Supreme electronics adhesives

MASTER BOND INC.: Non-Premixed and Frozen, One-Part Epoxy for Chip Coating

Supreme 3CCM-85 reportedly cures within 2-3 hrs at 175-185°F (80-85°C), which is advantageous for use on heat-sensitive components and substrates.

August 7, 2019

No Comments

Featuring a combination of thermal conductivity and electrical insulation properties, Master Bond Supreme 3CCM-85 is reportedly a new single-component epoxy initially designed for glob top and chip coating applications.