Columns

RSS

QUESTION: We use a UV adhesive/coating for assembling the plastic and metal components of a complex medical device. We need to optimize our curing process and ensure that the adhesive is fully cured with maximum properties. What are the most important factors?

Spring is such a great time of year. As the trees start to bud and the flowers peek up out of the dirt, we begin to feel like anything is possible.

In August 2012, the Environmental Protection Agency (EPA) and the National Highway Traffic Safety Administration (NHTSA) issued a joint final rule for Corporate Average Fuel Economy (CAFE) standards for 2017-2025.

As in previous years, this year’s handbook has been updated with many new products and definitions. The listings are divided into five major categories: Additives and Chemical Specialties; Oils and Fatty Acids; Resins and Base Polymers; Pigments and Dyes, Dry/Dispersions and Extenders; and Solvents.

QUESTION: In the manufacturing world, the recycling of materials and the use of “green” materials are popular trends that are increasingly coming under legislative pressures. What about the recycling of adhesives and sustainability in the adhesives industry?

Given any of the variety of adhesive and sealant products on the market, many ASI readers could probably determine the specific VOC rule and level that would apply.

The Consumer Electronics Association’s (CEA®) 2013 International CES event was held last month.

QUESTION: We have a lab freezer that goes down to -32°C, and the seals are torn and need replaced. What do you recommend?

Certain polymer-based adhesives are described as crystalline, while others are described as amorphous. How do these adhesive polymer types differ? What advantages could be expected from each type?

QUESTION: We have been advised to use an organosilane adhesion promoter in an acrylic adhesive to bond glass to metal.